FANDOM


E170 Ribbon calibration failed

Unplug the printer and laminator, plug them back in, and try to calibrate the ribbon in the driver again. If it still fails, REPLACE PRINTER


If the Firmware is older than 3.7.0 upgrading the Firmware may allow you to calibrate and clear this error. If not try leaving the power disconnected for several minutes before attempting to calibrate again.

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.